PG planetary reducer
This is a low-backlash planetary reducer with output shaft, suitable for intermittent operation with high positioning accuracy and high sensitive start. The output end uses high-quality tapered roller bearings, so that the output shaft can bear greater axial and radial loads.
High positioning accuracy
high torque
High starting
low noise
easy to install
Low tooth backlash
Long life, maintenance-free
PG technical data (single paragraph)
Note (1) This table is suitable for starting frequency within 1000 times/hour, if it exceeds, please contact our company.
Note (2) It can be used for 1000 times of action.
Note (3) The output speed of 100rpm acts on the center of the output shaft.
Note (4) The noise value is measured at 5 ratios/input speed 3000rpm/distance 1 meter/no load operation.
Continuous operation will reduce the service life of the reducer by half.
If the reduction ratio required by the customer is not listed in the table, please consult with our company.
PG Technical Information (Double Section)
Note (1) This table is suitable for starting frequency within 1000 times/hour, if it exceeds, please contact our company.
Note (2) It can be used for 1000 times of action.
Note (3) The output speed of 100rpm acts on the center of the output shaft.
Note (4) The noise value is measured at 5 ratios/input speed 3000rpm/distance 1 meter/no load operation.
Continuous operation will reduce the service life of the reducer by half.
If the reduction ratio required by the customer is not listed in the table, please consult with our company.
